Credo di aver risolto!!!
Ho trovato una nota tecnica sul sito di supporto
Garmin internazionale (nelle pagine italiane non c'è nulla) riguardo alla procedura di AutoLocate.
Per farla basta con l'
Edge 500 spento, tenere premuti contemporaneamente i tasti Start e Lap ed accenderlo.
Quando compare la schermata Garmin si possono rilasciare i tasti.
A questo punto si deve lasciare l'apparecchio per 20 minuti all'aperto in modo che possa ricrearsi i dati dei satelliti da zero.
Per chi non riuscisse a leggere la nota originale, come è successo inizialmente a me, incollo il testo originale:
Occasionally, satellite data can become obsolete or corrupt preventing the Edge 500 from acquiring a satellite lock. Performing an AutoLocate on the device removes all of the current satellite data and allows it to re-establish a proper connection with satellites.
An AutoLocate may also be necessary in the following circumstances:
- Device has not been used in over two weeks
- Device is powered on in a location that is 150 or more miles from where it is normally used
- Distance or speed data appears to be inaccurate as a result of a corrupt satellite signal
To perform an AutoLocate:
- Ensure the device is powered off
- Press and hold Lap and Start
- Press Power
- Release Lap and Start when the Garmin screen appears
- Leave the device outside with a clear view of the sky for a minimum of twenty minutes
Edge 500 will now have current satellite data, providing a good satellite lock. This will decrease the chance of inaccuracies in distance or speed.